This handy panel-raising fixture is the perfect choice for safely cutting precise raised panels, tenons or bevels. Just position the jig over your rip fence, tilt your table, slide your rip fence over, clamp your stock into position with the clamp bar and go to work. Make it from a good grade of 3/4-inch plywood with no voids.
We’ve provided three sets of dimensions (for the bottom portion of the fixture where it slips over your fence) to fit the three different MARK V rip fences -- Models 500, 510 and 520. By altering the C and E dimensions, the other dimensions will change as indicated.
Return to Steps 1 - 3
Return to Steps 4-6
Return to Steps 7-8