|
|
 |
|
|
STEP 2 -- Stop Drilling
Follow the procedures for through drilling . . . except set the MARK V’s depth control dial to limit the depth of your hole. All holes will be exactly the same depth . . . until you change the setting. Although no scrap block is necessary, using one, clamped to the table will help keep your stock from sliding. |
|
|
|
|
|
|
STEP 3 -- Angle Drilling
Tilt the worktable to drill any angle you prefer between “0” and 90-degrees and lock it into position. Mount your rip fence on the downside of the table. If your angle is steep, clamp scrap blocks to the table or use a V-Jig to protect the surfaces of the table and rip fence.
|
|
|
|
|
|
|
STEP 4 -- Drilling Round Stock
Mount the rip fence in the center of your worktable and tilt the table to 45? , forming a V-Block. Clamp scrap blocks to the table (or use V-Jig) to protect its surface. Lower the quill and adjust your table to align your bit point with the intersection of the table and fence. Insert workpiece and drill. Continue . . . |
|
|
|
|
