|
Partial profiles for thinner cabinet doors -- If just one side of your thinner (3/4-inch or so) cabinet door is to reveal a bead-and-cove edge on the outside of the door only, you'll be making a cut with one less Coping Cutter and Sticking Cutter.
Start with two of the largest of the six cutters (A,B) and set them in front of you in a configuration similar to that shown in Figure 4. This set-up will be used to cut the full length of the inside edges of both the stiles and rails, as indicated by "X" in Figure 1.
Now, take two of the smallest cutters (D,E) and set them in front of you in a configuration similar to that shown in Figure 4. This set-up will be used to cut the mirror-image profile in the ends of the rails, indicated by "Y" in Figure 1.
Continue
. . .
|
